Hot tub pump repair & replacement — Palm Beach County
No jets, a humming motor, grinding or a leak? We rebuild and replace pump motors, wet ends, seals and circulation pumps — flat-rate, same-day.
$69 diagnostic, credited to your repair
Same-day across Palm Beach County
Call (561) 555-0143Recognize any of these?
Tap the symptom that matches — each links to the likely cause and the flat price.
Pump won't turn on
A dead capacitor, failed relay or burned-out motor.
PumpHums but won't spin
A failed start capacitor or seized bearing.
PumpGrinding / screeching
Worn motor bearings or a dry shaft seal.
PumpPump leaking
A worn shaft seal, union or volute o-ring.
PumpNo jets / weak jets
A failing pump, air lock or clog.
PumpAir lock after refill
Trapped air stops the pump from priming.
The pump parts we carry and install
A pump is a motor plus a wet end. Many “pump” problems are just the wet end or seal — a cheaper fix than a full replacement.
Pump motors
1–4 HP single- and two-speed motors, with the right start/run capacitor.
Wet ends & impellers
Volutes, impellers and diffusers for Waterway, Aqua-Flo, LX and more.
Shaft seals & o-rings
The usual cause of a leaking or squealing pump — no full replacement needed.
Circulation pumps
Laing and Grundfos low-flow circ pumps behind quiet-running spas.
Published pump prices, confirmed before we start
We'll tell you whether a seal or wet-end repair will do, or a full pump is the smart call.
Diagnose, quote, fix, guarantee
Diagnose
We test the motor, capacitor and wet end to find the real fault — flat $69, credited.
Repair or replace
If a seal or wet end will fix it, we say so. If the motor's gone, you get the flat replacement price up front.
Install
We fit the correct pump — matched HP, voltage and union — and prime it properly.
Guarantee
We confirm full flow and no leaks, backed by our workmanship guarantee.
We service Waterway, Aqua-Flo by Gecko, Balboa/Vico, LX and Sundance/Jacuzzi Theramax pumps — most are universal across brands.
Answers before you call
Often we can repair it. A leak or squeal is usually just the shaft seal or wet end — from $239 — not a full pump. We only replace the motor when it's actually failed, and you'll know the price first.
Classic failed start capacitor or a seized bearing. The capacitor is an inexpensive fix; a seized motor needs replacement. We confirm which at the diagnostic.
Largely yes. Waterway, Aqua-Flo and LX pumps appear across many brands, so we can usually match and install the correct pump the same day.
A 1–2 HP jet pump starts at $489 and a 2.5–4 HP at $589, installed. Seal/wet-end repairs start at $239. See the full list above.
Let's get the water moving again.
Flat-rate from $239. Same-day. $69 diagnostic credited to your repair.
Tell us what's wrong — we'll call you back within the hour
No spam, no call center. Just a local tech who knows hot tubs and tells you the price before the work.
Quote request sent
We'll call you back within the hour. Hot tub out cold right now? Call us at (561) 555-0143.